![]() ![]() In our scenario, we have two drives available that are sdb and sdc. ![]() To find out the drives, run the following command in Terminal: $ sudo fdisk –lįrom the output of fdisk command, note down the names of the drives which should be something like sda, sdb, sdc. Now we have to identify what drives are available on our system to pool. If one drive fails, you can still access your data. In a mirrored pool, a single and complete copy of data is stored on all drive. However, If one drive fails, you will lose all your data. You can get combined storage and faster read/write speed. In a striped pool, copy of data is stored across all drives. There are two types of pool you can create: Then decide which drives to put in the storage pool. The first step while creating a ZFS storage pool is to know what type of pool you want to create. You will see the output similar to below.Īfter installation, we will create a pool of drives. To verify the installation, run the following command in Terminal: $ whereis zfs Wait for a while until the installation is completed. To install ZFS on Ubuntu 18.04 LTS, launch the Terminal by pressing Ctrl+Alt+T and then type the following command in it: $ sudo apt install zfsutils-linux We will use Ubuntu 18.04 LTS for describing the procedure mentioned in this article. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |